Cleaning the Airmega AP-1512HHS

MAKE SURE THE UNIT IS TURNED OFF AND DISCONNECTED FROM THE POWER PLUG BEFORE CLEANING
Do not use detergents that contain organic solvents (solvent, thinner, etc.), bleach, chlorine, or abrasives.
Please do not put the air purifier in water or spray water directly on it.

CLEANING THE AIR QUALITY INDICATOR [AQI] (every 2 months)

Use a soft brush or vacuum cleaner for the inlet and the air outlet of the air quality sensor.
Open the air quality sensor cover on the right-hand side of the unit.

1512HHS_-_AIR_QUALITY_SENSOR_1.jpg

Wipe the lens, and dust the inlet and outlet with a dry cotton swab.

1512HHS_-_AIR_QUALITY_SENSOR_2.jpg

Without regular cleaning, the performance of the air quality sensor deteriorates.
The cleaning cycle differs depending on the pollution of the surroundings.

 

 

CLEANING THE AIR INLET AND OUTLET

Clean the air inlet and outlet with a soft brush.

1512HHS_-_AIR_INLET_AND_OUTLET.jpg

Exercise caution not to have dust fall inside the air purifier.

If covered in dust, run the air purifier in manual mode for 10 minutes to blow the dust off the vent.

You may then continue with normal use.




CLEANING THE FRONT COVER

Separate the front cover from the rest of the unit.

1512HHS_-_FRONT_COVER.jpg
Use a soft cloth or brush to wipe off the dust on the surface of the front cover.
Use a lightly wet cloth if the contamination is high but do not use abrasives.

 

 

CLEANING THE MAIN BODY OF THE PRODUCT

 

1512HHS_-_PRODUCT_BODY.jpg

Use a dry and soft cloth to wipe the body of the product.
Use a lightly wet cloth if the contamination is high but do not use abrasives.