1. Coway
  2. AIRMEGA
  3. Airmega 1512HH / AP-1512HH (W) FAQ
Submit Request Icon

Back to Support Home
|
  1. Coway
  2. AIRMEGA
  3. Airmega 1512HH / AP-1512HH (W) FAQ
Cleaning the AP-1512HH / AP-1512HH(W)

MAKE SURE THE UNIT IS TURNED OFF AND DISCONNECTED FROM THE POWER PLUG BEFORE CLEANING
Do not use detergents that contain organic solvents (solvent, thinner, etc.), bleach, chlorine, or abrasives.
Please do not put the air purifier in water or spray water directly on it.

 

CLEANING THE AIR QUALITY SENSOR (every 2 months)

 

Use a soft brush or vacuum cleaner for the inlet and the air outlet of the air quality sensor.

AP-1512HH_Adjust_Air_Quality_Sensor_Cleaning_1.jpg

Open the air quality sensor cover on the right-hand side of the unit.
Wipe the lens, dust the inlet, and outlet with a dry cotton swab.

AP-1512HH_Adjust_Air_Quality_Sensor_Cleaning_2.jpg

Without regular cleaning, the performance of the air quality sensor deteriorates.
The cleaning cycle differs depending on the pollution of the surroundings.

 

 

CLEANING THE PRE-FILTER

 

Clean your Pre-filter by following the steps below (typically between 2-4 weeks depending on usage):
Open the front cover and gently pull it.
AP-1512HH_Pre-Filter_Cleaning_1.jpg

Press down on the top clip of the pre-filter to remove it.
AP-1512HH_Pre-Filter_Cleaning_2.jpg

Carefully wash with water or vacuum the pre-filter as needed.
MAKE SURE THE PRE-FILTER IS COMPLETELY DRY BEFORE INSTALLATION
AP-1512HH_Pre-Filter_Cleaning_3.jpg

Gently put the pre-filter back into its designated slot after drying and attach the front cover.
AP-1512HH_Pre-Filter_Cleaning_4.jpg

 

 

 

CLEANING THE FRONT COVER

 

Separate the front cover from the rest of the unit.
Use a soft cloth or brush to wipe off the dust on the surface of the front cover.
Use a lightly wet cloth if the contamination is high but do not use abrasives.

AP-1512HH_FRONT_COVER_CLEANING.jpg

 



CLEANING THE MAIN BODY OF THE PRODUCT (every 2-4 weeks)

 

Use a dry and soft cloth to wipe the body of the product.
Use a lightly wet cloth if the contamination is high but do not use abrasives.

AP-1512HH_BODY_CLEANING.jpg

 



Articles in this section

  • Adust Air Quality Indicator Sensitivity
  • Air Purification System of the AP-1512HH
  • Airmega AP-1512HH’s Air Quality Sensor Sensitivity
  • Cleaning the AP-1512HH / AP-1512HH(W)
  • Filter Replacement for Airmega AP-1512HH / AP-1512HH (W)
  • Setting up the Airmega AP-1512HH / AP1512-HH(W)
  • Understanding Airmega AP-1512HH’s Air Quality Light Indicator